[ngw] Block outgoing messages to specific address

Mike Lichtenwalner lichtemi at mtwp.net
Wed Aug 21 13:04:48 UTC 2013


Yes...double-checked that, too, sending to two different email addresses in the same domain. One was blocked (correctly) and one was not.

Thanks!


>>> On 8/21/2013 at 09:01 AM, <laurabuckley2000 at gmail.com> wrote: 
> Hi Mike, 
>  
> Just double-check that it hasn't blocked the entire domain! 
>  
> Kind regards, 
>  
> Buckley 
>  
>  
> On Wed, Aug 21, 2013 at 2:55 PM, Mike Lichtenwalner <lichtemi at mtwp.net>wrote: 
>  
> > Nevermind.... Yes, you can block individual email addresses via C1 - I 
> > just needed to restart the GWIA after making that change. 
> > 
> > Sorry for the idle chatter.... 
> > 
> > 
> > >>> On 8/21/2013 at 08:26 AM, <Lichtemi at mtwp.net> wrote: 
> > > Hi All, 
> > > 
> > > I received a request to not allow any of our users (single PO, GW2012 
> > SP2, 
> > > SLES10SP4) to send emails to a specific email address. In the given 
> > > situation, this is a very legitimate request. 
> > > 
> > > In the GWIA properties in C1 (Access Control -> Class of Service -> SMTP 
> > > Outgoing), I can prevent messages from being delivered to an entire 
> > domain, 
> > > but I'm not sure that I can block a single email address there. 
> > > 
> > > Is there a way for GW to do this? 
> > > 
> > > Thanks! 
> > > Mike 
> > > 
> > > 
> > > _______________________________________________ 
> > > ngw mailing list 
> > > ngw at ngwlist.com 
> > > http://ngwlist.com/mailman/listinfo/ngw 
> > > 
> > 
> > 
> > _______________________________________________ 
> > ngw mailing list 
> > ngw at ngwlist.com 
> > http://ngwlist.com/mailman/listinfo/ngw 
> > 
> _______________________________________________ 
> ngw mailing list 
> ngw at ngwlist.com 
> http://ngwlist.com/mailman/listinfo/ngw 
>  




More information about the ngw mailing list